Living in a 20-year-old house with pre-installed Cat5e wiring, I faced a dilemma when video editing work demanded more than my gigabit network could deliver. Rather than undertaking the massive project of rewiring with Cat6/6a (as specified by 802.3an for 10GbE), I decided to test if my existing Cat5e infrastructure could handle 10GbE speeds.

Test Setup

• Server: NAS with AQC107 10GbE card
• Client: 2025 Mac Mini with 10GbE upgrade
• Testing Tools: iperf3 for throughput testing, ping for latency checks
• Switches: Hasivo S1100WP-8xgt-se(Switch1) and Netgear GS110EMX 10GbE Switch (Switch2)

Results

Test 1 (Baseline test): Direct Connection BaselineServer – Client (short Cat6 cable, 3ft)

• Speed: 9.23Gbps bidirectional
• Latency: ~0.3ms
• Error rate: 0%
• Duration: 10 seconds iperf3 test
• Notes: This established our baseline performance with ideal conditions using Cat6

Test 2: Switch Connection with Short CablesServer – Switch – Client (short Cat5e cables, 3ft each)

• Speed: 9.24Gbps bidirectional
• Latency: ~0.4ms
• Error rate: 0%
• Duration: 1-hour iperf3 test
• Notes: Introducing a managed switch and Cat5e cables maintained full performance

Test 3: Full House Infrastructuretext

Server [AQC107] 
    └── 3ft Cat5e 
        └── Switch1 [QNAP QSW-M2108]
            └── 1ft Cat5e patch cable
                └── Patch Panel
                    └── 120ft in-wall Cat5e (attic run)
                        └── Switch2 [QNAP QSW-M2108]
                            └── 25ft Cat5e
                                └── Wall Plate
                                    └── 4ft Cat5e
                                        └── Client [Mac Mini]

• Speed: Stable 9.24Gbps bidirectional
• Latency: ~0.9ms
• Error rate: 0%
• Duration: 24-hour continuous iperf3 and ping test.
• Notes: Despite multiple connection points and significant length, performance remained solid with no degradation over time

Test 4: Extended Run With Long Mixed Cabling

Server [AQC107]
    └── 3ft Cat5e
        └── Switch1 [QNAP QSW-M2108]
            └── 1ft Cat5e patch cable
                └── Patch Panel
                    └── 120ft in-wall Cat5e (attic run)
                        └── Switch2 [QNAP QSW-M2108]
                            └── 25ft Cat5e
                                └── Wall Plate
                                    └── 75ft Cat6 extension
                                        └── Client [Mac Mini]

• Result: Only negotiated to 100Mbps
• Diagnostics: Link training failed at 10Gbps and 1Gbps
• Signal quality: Significant attenuation and crosstalk detected
• Total distance: ~225ft (exceeding practical limits)
• Notes: The total cable length appeared to exceed Cat5e’s capabilities for 10GbE, with the additional 75ft extension pushing beyond workable limits

Additional Observations

• Cable quality varies significantly between manufacturers
• Proper termination is critical – poorly crimped RJ45 connectors caused intermittent issues
• Adjacent power lines caused interference in one test location, try to avoid run ethernet cables in parallel with power lines.

Conclusion

While not officially supported, Cat5e cables can deliver 10GbE performance in home environments with reasonable cable lengths (under ~150ft total). This can save significant time and expense when upgrading from gigabit networks. However, be prepared to fall back to gigabit speeds for longer runs or when cable quality is inconsistent.